Velvet Drive Transmission Will Not Engage. Just installed two new pcm motors in my carver. My velvet drive was slipping, so i rebuilt it, on 1st test run engaged rev. When shifting to forword it slipped slightly the. The oil pressure sounds sufficient to properly engage the clutch packs, so must be either the oil flow to clutches or the clutch. What is the best way. I would disconnect the shift cable at the transmission there is a spring detente for each position manually shifting by hand if the transmission engages properly. When i try to engage reverse gear, the engine goes out. We put a ton of effort into deturmining which was standard and which was reverse but are not 100% sure of. Velvet drive transmissions can not operate if the angle exceeds 15 degrees with the boat at rest, or 20 degrees with the boat under way in the full. The control valve moves correctly, but the transmission is always. I'm looking to educate myself, and make this thing run. Linkage moves but valve doesn't seem to engage. I can’t work out why my clutch pack has failed?
from boatdiesel.com
We put a ton of effort into deturmining which was standard and which was reverse but are not 100% sure of. I'm looking to educate myself, and make this thing run. My velvet drive was slipping, so i rebuilt it, on 1st test run engaged rev. The oil pressure sounds sufficient to properly engage the clutch packs, so must be either the oil flow to clutches or the clutch. Velvet drive transmissions can not operate if the angle exceeds 15 degrees with the boat at rest, or 20 degrees with the boat under way in the full. Linkage moves but valve doesn't seem to engage. When i try to engage reverse gear, the engine goes out. The control valve moves correctly, but the transmission is always. I would disconnect the shift cable at the transmission there is a spring detente for each position manually shifting by hand if the transmission engages properly. Just installed two new pcm motors in my carver.
Velvet Drive Marine Transmissions
Velvet Drive Transmission Will Not Engage The control valve moves correctly, but the transmission is always. My velvet drive was slipping, so i rebuilt it, on 1st test run engaged rev. When shifting to forword it slipped slightly the. Just installed two new pcm motors in my carver. I'm looking to educate myself, and make this thing run. We put a ton of effort into deturmining which was standard and which was reverse but are not 100% sure of. Velvet drive transmissions can not operate if the angle exceeds 15 degrees with the boat at rest, or 20 degrees with the boat under way in the full. The oil pressure sounds sufficient to properly engage the clutch packs, so must be either the oil flow to clutches or the clutch. I can’t work out why my clutch pack has failed? Linkage moves but valve doesn't seem to engage. When i try to engage reverse gear, the engine goes out. I would disconnect the shift cable at the transmission there is a spring detente for each position manually shifting by hand if the transmission engages properly. The control valve moves correctly, but the transmission is always. What is the best way.
